Lithography Projector Mod – Color Wheel Removal

When modifying a projector for photolithography, one thing to note is the UV transmission quality of the optics. Often, the stock color wheel in most DLP projects attenuates that UV significantly on the clear and blue sections. Thus, it is beneficial to remove it however the projector has RPM feedback (from motor back-EMF and/or photodiode) so simply removing it will result in the projector not starting up. A simple RC relaxation circuit can be built to emulate this signal (often 60 or 120hz) so that the projector will function properly.

The circuit shown below is approximate. The 2.4uF capacitor and 3.3KΩ resistor set the frequency of oscillation.

The completed circuit is probed and verified using an oscilloscope, using channels 1 and 2 which display the oscillator output and capacitor charging waveforms, respectively, in the last photo.

In the end, the projector is “fooled” into operating with monochrome light output without a color wheel.

One thought on “Lithography Projector Mod – Color Wheel Removal”

  1. Dear Sam
    Fill good to seen your whole research and project it’s excellent reactor and design and your achievement, I m trying developing
    Mw plasma Cvd reactor for growing diamond I need some help with design and development so please if you interested in
    Development reply
    Thanks
    Bhavesh

Leave a Reply to Bhavesh Cancel reply

Your email address will not be published. Required fields are marked *